24
Installation
4.2 Positioning
Check that the power supply voltage to the device matches that one shown on the
regulatory label on the rear panel, that the power outlet is designed to supply at
least 16A and that it has an earth connection.
If the installation makes the main power switch inaccessible, a specially
dedicated accessible electrical disconnection switch should be provided.
The manufacturer is not liable for damage to property or persons caused by electrical systems that are
unsuitable or have no earth connections.
The device must be installed on a flat surface. If the support surface is
perfectly horizontal, the front feet are already adjusted with a slight
inclination to facilitate the flow of water during draining.
If the support surface is not perfectly level, adjust the front legs, raising
or lowering them to obtain a slight inclination, as shown in the figure.
Do not place the device on a fragile surface that could be damaged or cause fire or smoke if hot objects fall.
For proper operation, leave a free space of at least 5 cm between the
rear of the device and any wall.
Do not install the device near heat sources or in damp or poorly
ventilated spaces. The room must provide air circulation with at least
10 air changes per hour; a recirculating air ventilation system (e.g., an
electric fan) cannot be used as an alternative.
The safety valve is on the rear of the device. When triggered by excess pressure, it releases
very hot steam into the environment. Position the device to avoid risk of burns to the operator.
> 5 cm
To Next Page
Loading...
