NVR SYSTEMS 4-CH - Page 31

31
Miscellaneous function specific operations:
Active function
Operations
Descriptions
Focus
+/-
Auto
focus far/near
auto focus
Iris
+/-
Iris increase/decrease
Auto Pan
Select Value
Run/ Stop
Set Start
Set Stop
Auto pan speed is shown in the center
increase/decrease speed
start/stop Auto Pan
set start position
set end position
Sequence
Select Value
Run/ Stop
SEQ dwell time is shown in the center.
If SEQ mode is on, the camera will go to
preset position 0-9 (or 1-10) sequentially.
change dwell time
start/stop SEQ mode
Preset
Select Value
Set
Clear
Preset location is shown in the right lower
corner
change Preset location
set Preset location
clear Preset location
Pan Speed
Select Value
Manual pan speed is shown in parenthesis
increase/decrease speed