5.5.1 Notification Setup
In Network Setup, press Notification
to call up Notification Setup as
shown.
The Notification Setup allows the
administrator to set notification
(email & push alarm) related
parameters. When an event occurs
and Notification/E-mail is enabled
for the corresponding action, a
notification will be sent based on
the parameters set.
The general operations are as below:
Mouse: Click in the respective item
Select the items to set.
X (Mouse: Left Click X or Right Click to leave)
Press this button to escape from this screen, and return to Network Setup display. If
the Save dialog is shown, press YES to exit and save, CANCER to exit without saving.
Following is a brief description for each item and its specific operations:
SMTP Server – SMTP mail server name. Please follow the Text Input method described
in Section 4.1 to modify this item.
SMTP Port – the SMTP port for e-mail transmission. The default value is 25. Please
follow the Text Input method described in Section 4.1 to modify this item.
Authentication – whether the SMTP mail server requires authentication.
Username – username if the SMTP mail server requires authentication. Please follow
the Text Input method described in Section 4.1 to modify this item.
Password – password if the SMTP mail server requires authentication. Please follow the
Text Input method described in Section 4.1 to modify this item.
Mail From – the e-mail address of this DVR unit, i.e. the sender of the e-mails originated
from the triggered events. Please follow the Text Input method described in Section 4.1
to modify this item.
Mail To #1-5 – the receivers’ e-mail addresses. The system can send the e-mails
originated from the triggered events to up to 5 different receivers. Please follow the
Text Input method described in Section 4.1 to modify these items.
Attachment – attached picture for the e-mail sent. The value could be (N/A, Original
picture, QCIF picture).
Push Alarm – whether Push Alarm is enabled for network notification.
To Next Page
Loading...