Clear (Mouse: Left click)
Press this button to clear the HDD. A confirmation dialog will be shown on the screen.
Press YES to confirm, or CANCEL to cancel.
Note: If the HDD has not been formatted, it will be formatted and partitioned with
default record size, 100% for Alarm record and 0% for Normal record. If it has
been formatted (and recorded), it will be partitioned according to the Alarm
Record Size (%) and Normal Record Size (%) displayed on the screen and the
previously recorded contents will all be cleared.
Physical Format (Mouse: Left click)
Press this button to physically format the selected HDD. A confirmation dialog will be
shown on the screen. Press YES to confirm, or CANCEL to cancel. Please note that the
recording will be always optimized for performance & lifetime no matter it’s for the
first time or for the one hundredth time. The formatting would take less than 1
minute. We strongly recommend that the user use this physical format function to
format the HDD for the first time.
Note: The HDD will be physically formatted and partitioned with default record size,
100% for Alarm record and 0% for Normal record. All the previously recorded
contents will be cleared.
Following is a brief description for each item and its specific operations:
Size (GB) – the total storage in GB (Giga-Byte) for the HDD if it has been formatted.
This item is just for information.
Alarm Record (%) – Alarm Record Size (in percentage) for this HDD. Please follow the
Text Input method described in Section 4.1 to change the value. Please note that if
the alarm record percentage for all HDDs is zero, the alarm video/audio will be
recorded in normal record partition. If the total normal record size is zero, the
normal video/audio will be recorded in alarm record partition.
Normal Record (%) – Normal Record Size (in percentage) for this HDD. It equals to
(100% - Alarm Record Size). This item is just for information.
NAS/Setup – used to setup NAS (Network Attached Storage) related parameters if
NAS is connected to the DVR. Press Setup (Mouse: Left click) to call up NAS Setup
display as shown.
To Next Page
Loading...