NXP Semiconductors MPC5777M - Page 150

MPC5777M Microcontroller Data Sheet, Rev. 6
Document revision history
NXP Semiconductors150
2 4/2013
Ordering Information
Section 4, Ordering information:
•New
3 3/2014
Throughout
• Changed document ID to “MPC5777M.”
• Updated the “e200_z720n3” cores to “e200_z710n3” and the “e200_z719” core to
“e200_z709.”
• Removed references to the 292 MAPBGA and LFBGA292 packages.
• Editorial (non-technical) changes and improvements.
• Removed references to KGD and 165
o
C ratings.
Introduction
Table 1 (Family comparison):
• SPC5744K column, ADC (SD) feature, changed “3” to “2”.
• MPC5777M column, removed 292 MAPBGA.
• Changed feature from “SIPI/LFAST
7
bus” to “Zipwire

(SIPI / LFAST
7
) Interprocessor
Communication Interface”.
• Removed “To be confirmed for final silicon” footnote from Local RAM row for
SPC5744K.
• Removed “Only on the I/O processor core” footnote from LSP row for all devices.
• Changed System SRAM for MPC5777M to “404 KB” (was 384 KB).
• Changed Flash memory for MPC5777M to “8640 KB” (was 7.9 MB).
• Changed DMA Nexus Class for SPC5744K, MPC5746M, and MPC5777M to “3+” (was
3).
• Changed GTM RAM for MPC5777M to “58 KB” (was 52 KB).
• Changed Interrupt Controller entry for MPC5777M to “727 sources” (was 930 sources).
• Removed “Integrated switch mode voltage regulator” row.
• Removed “Degraded performance below 4.0 V” footnote from 5 V value in External
power supplies row.
Figure 1 (Block diagram):
• Updated the “e200_z720n3” cores to “e200_z710n3” and the “e200_z719” core to
“e200_z709”.
Section 1.5, Feature overview
• Changed item describing main CPUs to “single issue” (was “dual issue).
• Changed item describing on-chip flash memory to “8640 KB” (was “8528 KB”).
• Removed FlexRay as an option for BAM serial port.
Table 76. Revision history (continued)
Revision Date Description of changes