NXP Semiconductors MPC5777M - Page 24

MPC5777M Microcontroller Data Sheet, Rev. 6
Electrical characteristics
NXP Semiconductors24
V
DD_HV_ADR_D
SR SD ADC supply
reference voltage
Reduced SNR 3.0 V
DD_HV_ADV_D
4.5 V
Full SNR 4.5 5.5
32
V
DD_HV_ADR_D
–
V
DD_HV_ADV_D
SR SD ADC reference
differential voltage
———25mV
V
SS_HV_ADR_D
SR SD ADC ground
reference voltage
—V
SS_HV_ADV_D
V
V
SS_HV_ADR_D
–
V
SS_HV_ADV_D
SR V
SS_HV_ADR_D
differential voltage
— –25 — 25 mV
V
DD_HV_ADR_S
35
SR SARADC reference — 2.0 V
DD_HV_ADV_S
4.0 V
4.0 5.5
32
V
SS_HV_ADR_S
SR SAR ADC ground
reference voltage
—V
SS_HV_ADV_S
V
V
DD_HV_ADR_S
–
V
DD_HV_ADV_S
SR SARADC reference
differential voltage
———25mV
V
SS_HV_ADR_S
–
V
SS_HV_ADV_S
SR V
SS_HV_ADR_S
differential voltage
— –25 — 25 mV
V
SS_HV_ADV
– V
SS
SR V
SS_HV_ADV
differential
voltage
— –25 — 25 mV
V
RAMP_LV
SR Slew rate on core
power supply pins
———100V/ms
V
RAMP_HV
SR Slew rate on HV power
supply pins
———100V/ms
V
por_rel
CC POR release trip point -40 °C < Tj < 150 °C 3.10 — 4.26 V
V
por_hys
CC POR hysteresis -40 °C < Tj < 150 °C 150 — 300 mV
V
IN
SR I/O input voltage range — 0 — 5.5 V
Injection current
I
IC
SR DC injection current
(per pin)
36,37,38
Digital pins and analog
pins
–3.0 — 3.0 mA
I
MAXSEG
SR Maximum current per
power segment
39
— –80 — 80 mA
1
The ranges in this table are design targets and actual data may vary in the given range.
2
Maximum operating frequency is applicable to the computational cores and platform for the device. See the Clocking chapter
in the MPC5777M Microcontroller Reference Manual for more information on the clock limitations for the various IP blocks
on the device.
3
Core voltage as measured on device pin to guarantee published silicon performance.
4
During power ramp, voltage measured on silicon might be lower. maximum performance is not guaranteed, but correct
silicon operation is guaranteed. Refer to the Power Management and Reset Generation Module chapters in the MPC5777M
Microcontroller Reference Manual for further information.
Table 8. Device operating conditions
1
(continued)
Symbol Parameter Conditions
Value
Unit
Min Typ Max