Oce TC4 - Page 33

Steps in an extended scan-to-file job without fine tuned job templates
1.
Feed the original.
2.
Define the scan-to-file job settings at the scanner operator panel.
■
Open a template.
■
Select the first setting and define the value.
■
Select the second setting and define the value.
■
....
■
Select the last setting and define the value.
3.
Press the green start key.
Result
The second step takes several additional actions.
Steps in an extended scan-to-file job with fine tuned job templates
1.
Feed the original.
2.
Define the job settings.
Select the required template at the scanner operator panel and change the pre-defined
settings only if necessary.
3.
Press the green start key.
Result
You get a tuned digital file of your original.
Chapter 2 - Use the Océ TC4 33
Introduction to scan-to-file jobs