Oce TC4 - Connecting to the Controller

Connect to the controller
Introduction
After you start Océ Power Logic
®
controller Remote, you must connect to the Océ TC4
Power Logic
®
controller.
You can do the following when you connect to the controller.
■
Select a system from the drop-down list.
■
Add a system to the drop-down list.
■
Remove a system from the drop-down list.
When the Océ TC4 is not available in the 'Connect to' window, you must add the Océ
TC4 to the list of available systems.
How to connect to a system
1.
Run the application.
2.
From the 'File' menu, select 'Connect to'.
3.
Select the system from the drop-down list.
4.
Click 'OK'.
Note:
From the 'Edit' menu, select 'Options' to define the default system. This is recommended
if you frequently connect to the same system.
How to add a system
1.
From the 'File' menu, select 'Connect to'.
2.
Click 'Edit'.
The 'Edit systems' dialog box appears.
3.
Enter the IP address or the name of the system in the 'Systems' box.
4.
Click 'Add'.
The system is added to the list.
5.
Click 'OK' 2 times to return to the application.
How to remove a system
1.
From the 'File' menu, select 'Connect to'.
2.
Click 'Edit'.
Chapter 3 - OcéPower Logic
®
controller Remote
74
Connect to the controller