This chapter describes how to use the scanner.
Use the scanner operator panel
Introduction
Use the scanner operator panel to define the job settings. You can define the job settings
in two ways.
■
Use the left softkeys and the scroll wheel.
You can use this method if you prefer a general step by step method.
■
Use the scroll wheel and scroll-wheel key only.
You can use this method if you prefer a fast method.
Note that the scanner operator panel also uses icons to explain a setting. The following
illustration shows the scanner operator panel. For more information about the keys on
the ‘Scanner operator panel’ on page 179
Chapter 2 - Use the Océ TC428
Use the scanner operator panel
To Next Page
Loading...
