Oce TC4 - Remove Strip Settings

'Remove strip'
Use the 4 settings below to define the blank areas around the image.
Remove strips#
ResultIconSetting
Use this setting to remove a strip at the
top of the image. This action decreases
the image length.
Note:
The top side of the image is the
side that you first feed into the
scanner.
'Remove strip' -
'Leading'
Use this setting to remove a strip at the
bottom of the image. This action decreas-
es the image length.
'Remove strip' -
'Trailing'
Use this setting to remove a strip from
the left side of the image/original viewed
from the face-up direction. This action
decreases the image width.
'Remove strip' -
'Left'
Use this setting to remove a strip from
the right side of the image/original viewed
from the face-up direction. This action
decreases the image width.
'Remove strip' -
'Right'
Chapter 2 - Use the Océ TC4 45
'Remove strip'