Oce TC4 - Viewing Scanned Files with Océ View Station LT

Océ View Station LT
®
View locally scanned files with Océ View Station
®
LT
Introduction
With the use of the software application (Océ View Station
®
LT) you can automatically
view a file after scanning or you can view a locally stored scanned file. You can configure
the settings for Océ View Station
®
LT in such a way that the scanned file is opened auto-
matically.
Purpose
Check the quality of the scanned file before you archive the scanned file.
Before you begin
Make sure you have sufficient permissions when you log on to the Océ TC4 Power
Logic
®
controller application.
■
'Anonymous' - permission, editing and other actions are allowed
■
Repro operator - permission, editing and other actions are allowed
■
Key operator - permission, editing and other actions are allowed
■
System administrator - permission, editing and other actions are allowed
Note:
It is not possible to view scanned files that are stored at a remote location.
You cannot use Océ Power Logic controller Remote to view scanned files.
How to view a file automatically after scanning
1.
Open the Océ TC4 Power Logic
®
controller application.
2.
Open the 'System' menu and select Autoview.
Result
When you scan to file the next time, Océ View Station
®
LT will start up a secondary
window and show the scanned file. If the autoview function is not enabled you can use
Chapter 2 - Use the Océ TC4 61
View locally scanned files with Océ View Station
®
LT