Oce TC4 - Page 60

Retrieve files via an FTP command line prompt
1.
Launch an FTP client.
2.
Enter the ‘FTP’ command.
A DOS box now appears with the FTP prompt.
3.
Enter the ‘Open’ command followed by either the registered name of the Océ Power
Logic
®
controller or the IP address (for example: 194.2.66.146) to connect to the controller
and press Enter: ‘open 194.2.66.146’.
The connection with the controller is now established and a window appears asking you
for a user name.
4.
Enter your user name ‘Anonymous’, and enter as your password also ‘Anonymous’.
A connection is now set up for the default user ‘Anonymous’.
5.
Set the transmission mode to binary by entering ‘Binary’.
6.
Go to the ‘Tempstore’ directory using the following command: ‘cd tempstore’.
7.
Go to the ‘Scan’ directory if you want to retrieve a file from a destination on the local
host,
or
go to the ‘Unsent’ directory if you want to retrieve a file from ‘Unsent’ folder on the local
host.
8.
Get the data file (for example: bugatti.tif) via the ‘Get’ command.
9.
Quit FTP by entering the ‘bye’ command.
Chapter 2 - Use the Océ TC460
How to retrieve scanned files via FTP