15
The Odyssey
®
Imager and network switch are designed to operate
continuously. During idle times, the Odyssey Imager can remain
powered on or be powered off at your discretion. When idle, the
Odyssey Imager uses approximately 0.5 amp of power, about the
same as a light bulb. If the Odyssey Imager needs to be powered off
(when moving it, for example), see
Powering Off The System
below.
Width
25
Height
Origin (X,Y)
X-Axis (cm)
Y-Axis (cm)
0
0
25
Sample
Figure 2-3. Scans start at the lower left hand corner of the scanning
surface and progresses across the X-axis and up the Y-axis.
Continuous Operation
To Next Page
Loading...
