Oki MB491 - Registering Network Scan Destinations

Registering Network Scan Destinations
-112-
z Registering Network Scan Destinations
This section explains how to register a PC connected to the Network.
You can register locations on a network to which you can scan documents.
Memo
z You can also register network-connected PCs with ActKey in Network Configuration. You can register or delete network-
connected PCs with Network Configuration, however, you cannot edit them. For details, refer to User's Manual Advanced.
Registering and Editing
Reference
z For details on how to enter text, refer to "Entering Text
Using the Operator Panel" P. 26.
1 Press the <SETTING> key on the
operator panel.
2 Press the to select [Network Scan
Destination] and then press .
3 Press the to select an IP address or
domain name and then press .
4 Check that [Register] is selected and
then press .
If editing registered numbers, select [Edit].
5 Check that [Destination] is selected
and then press .
6 Enter a destination.
A destination up to 16 characters.
7 Select [Enter] and then press .
8 Press the to select [Destination
Address] and then press .
9 Enter an IP address or a Host PC name.
An IP address or a name up to 64 characters.
10 Select [Enter] and then press .
11 Press the to select [Port No.] and
then press .
12 Enter a port number and then press .
13 Press .
14 Press the until the top screen is
displayed.
Deleting
1 Press the <SETTING> key on the
operator panel.
2 Press the to select [Network Scan
Destination] and then press .
3 Press the to select a number and then
press .
4 Press the to select [Delete] and then
press .
5 Press the or to select [Yes] on the
confirmation screen and then press .
6 Press the until the top screen is
displayed.
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK