Oki MB491 - Making Duplex Copies (Duplex Copy); Adjusting Copy Density (Density); Changing Document Type (Document Type)

Configuring Copy Settings
-77-
Copying
2
Making Duplex Copies (Duplex
Copy)
You can copy 1-sided (simplex) and 2-sided
(duplex) documents on to one side (simplex) or
both sides (duplex) of a sheet of paper. You can
also select the binding position from either long-
edge or short-edge binding.
Specify the appropriate orientation of the
document in [Direction] beforehand to get the
copy result you want.
Note
z Use standard size plain paper for duplex copies. Using
non-standard paper may cause a paper jam in the duplex
unit of your machine.
Duplex printing cannot be done while paper is fed by
Manual Feeder in MB461.
Reference
z For details on the available paper for your machine, refer
to "Loading Paper" P. 32.
z For details on how to configure the [Direction] setting,
refer to "Changing Image Orientation of Document
(Direction)" P. 75.
 Long-Edge Binding
Copies your document to be bound along the
long edge of the paper.
 Short-Edge Binding
Copies your document to be bound along the
short edge of the paper.
Reference
z To set margins for binding, refer to the User's Manual
Advanced.
Enabling Duplex Copies
1
Press the to enter the [Change
Settings] menu.
2 Press the to select [Duplex Copy]
and then press .
3 Press the to select the desired value
and then press .
4 Press the until the start screen is
displayed.
Note
z You can copy "duplex to duplex" or "duplex to simplex"
copies only when scanning the documents from the ADF.
Memo
z When making duplex copies using the document glass, the
continuous scan mode is automatically enabled. Follow the
on-screen instructions.
Adjusting Copy Density
(Density)
You can adjust the copy density from 7 levels.
1 Press the to enter the [Change
Settings] menu.
2 Press the to select [Image Settings]
and then press .
3 Check that [Density] is selected and
then press .
4 Press the or to select the desired
density and then press .
Memo
z [0] is the standard value. To darken the document
image, select [+1], [+2] or [+3] (most dense).
Conversely, to lighten the document image, select
[-1], [-2] or [-3] (least dense).
5 Press the until the start screen is
displayed.
Changing Document Type
(Document Type)
You can select the document type to make copies
at the most suitable quality for your needs.
1 Press the to enter the [Change
Settings] menu.
OK
Settable Values for Printing Method:
OFF (Simplex)*
Simplex document → Duplex LE
Simplex document → Duplex SE
Duplex document → Duplex printing
Duplex LE → Simplex printing
Duplex SE → Simplex printing
*indicates the factory default.
Settable Density Values:
+3 +2 +1 0* -1 -2 -3
*indicates the factory default.
OK
OK
OK
OK