Oki MB491 - Installing a Printer Driver

Connecting to a Computer
-50-
Installing a Printer Driver
(For Mac OS X)
To complete the network connection with a Mac
operating system, install a printer driver on the
computer and set your machine as a network
printer.
Select the protocol for your network connection
from the following:
z EtherTalk
z Bonjour
Note
z EtherTalk is not supported in Mac OS X 10.6 or later.
z Disable the anti-virus software before starting this
procedure.
z EtherTalk is not supported in Mac PCL.
 Using EtherTalk (For Mac OS X
10.5)
When connecting to the network with EtherTalk,
it is necessary to enable EtherTalk in the
machine. Then, install the driver in the computer.
 First, enable EtherTalk in the machine.
1 Ensure that your machine and the
computer are turned on and connected.
Reference
z "Connecting an Ethernet Cable" P. 47
2 Press the <SETTING> key on the
operator panel.
3 Press the to select [Admin Setup],
and press .
4 Enter the administrator password.
The factory default password is "aaaaaa".
5 Select [Complete], and press .
6 Press the to select [Network Menu],
and press .
7 Press the to select [Network Setup],
and press .
8 Press the to select [EtherTalk], and
press .
9 Press the to select [Enable], and
press .
10 Press the until the top screen is
displayed.
 Next, install the driver in the computer.
1 Insert the "Software DVD-ROM" into the
computer.
2 Double-click the [OKI] icon on the
desktop.
3 Double-click [Driver] > [Printer] >
[Installer for MacOSX].
4 Enter the administrator's password, and
then click [OK].
Follow the instructions displayed on the screen to
complete the installation.
5 From the Apple menu, select [System
Preferences].
6 Click [Print & Fax].
7 Click [+].
8 Click [AppleTalk].
OK
OK
OK
OK
OK
OK