Oki MB491 - Using Ethertalk

Connecting to a Computer
-51-
Setup
1
9 Select the name of your machine and
then check that [OKI MB491(PS)] is
displayed in [Print Using].
10 Click [Add].
11 Check that your machine is displayed in
[Printers] and [OKI MB491(PS)] is
displayed in [Kind].
Note
z If [OKI MB491(PS)] is not correctly displayed in
[Kind], click [-] to remove your machine from [Print
& Fax] and then redo the procedure from steps 7 to
10.
12 Close [Print & Fax].
13 Remove "Software DVD-ROM" from the
computer.
The installation is complete.
 Using EtherTalk
(For Mac OS X 10.4.0 to 10.4.11)
When connecting to the network with EtherTalk,
it is necessary to enable EtherTalk in the
machine. Then, install the driver in the computer.
Memo
z The following procedure uses Mac OS X 10.4.11 as an
example. Depending on an OS, the description may be
different.
 First, enable EtherTalk in the machine.
1 Ensure that your machine and the
computer are turned on and connected.
Reference
z "Connecting an Ethernet Cable" P. 47
2 Press the <SETTING> key on the
operator panel.
3 Press the to select [Admin Setup],
and press .
4 Enter the administrator password.
The factory default password is "aaaaaa".
5 Select [Complete], and press .
6 Press the to select [Network Menu],
and press .
7 Press the to select [Network Setup],
and press .
8 Press the to select [EtherTalk], and
press .
9 Press the to select [Enable], and
press .
10 Press the until the top screen is
displayed.
 Next, install the driver in the computer.
1 From the Apple menu, select [System
Preferences].
2 Select [Network].
OK
OK
OK
OK
OK
OK