Oki MB770dn - Changing the Administrator Password and Resetting the Service Password

SETTING ITEMS (ADMIN)
- 235 -
2
1
3
4
5
6
7
You can specify up to three E-mail addresses for the
destination of the notification message.
Memo
• You can specify events that you want to be notified about
using the TopAccess web utility. For instructions on how to
specify events for notification, refer to the TopAccess
Guide “Chapter 8: [Administration] Tab Page".
Note
• To enable this function, there must be a SMTP server in
your network. In addition, the settings to enable Internet
communication on this equipment must be configured
correctly.
1
On the NOTIFICATION screen, press [E-
MAIL].
The on-screen keyboard is displayed.
For details of the on-screen keyboard, see the following
page:
 P.300 "On-screen keyboard"
2
Enter the E-mail address and press [OK].
Memo
• You can specify up to three E-mail addresses to which
notification messages will be sent, if needed. To
enable notification, you must have at least one E-mail
address entered.
3
Press [ON] for the E-mail address to receive
notification, and then [OK].
To disable notification for an E-mail address, press [OFF].
Note
• [ON] is available only after an E-mail address is
entered.
Changing the administrator password
and resetting the service password
You can change the administrator password.
1
On the PASSWORD SETUP screen, press
[ADMIN PASSWORD] or [RESET SERVICE
PASSWORD].
The screen for changing the administrator password is
displayed.
If [RESET SERVICE PASSWORD] has been selected,
the message "Are you sure?" is displayed on the
ATTENTION screen.
Press [YES] to reset the service password.
2
Press [OLD PASSWORD].
The on-screen keyboard is displayed.
For details of the on-screen keyboard, see the following
page: