SETTING ITEMS (ADMIN)
- 275 -
[DYNAMIC WEP] — Select this to use an encryption
which automatically updates the WEP key. DYNAMIC
WEP does so periodically as well as automatically.
Note
• To select [TKIP] or [AES (CCMP)], press [WPA] or
[WPA2], or to select [DYNAMIC WEP], press [802.1X].
Memo
• The encryption intensity between each encryption is:
AES(CCMP) > TKIP > DYNAMIC WEP
7
Specify the following items and press
[NEXT].
• TRANSMIT POWER
Select the low transmit power if you want to limit the area
that the wireless communication is enabled. If you do not
have to limit the area, select [100%].
8
Confirm the settings and press [FINISH].
Memo
• If you want to change the settings, press [PREV] to
move back to the screen that you want to change and
then repeat the operation.
9
Press [YES], and wait until the setting is
reflected.
Selecting WPA/WPA2/802.1X security mode
with PEAP protocol
Using the WPA/WPA2/802.1X with the PEAP protocol, you
must install the CA certification file in the equipment. This
equipment uses the user name and password to authenticate
the access rights to the wireless network, and the RADIUS
server authenticate this equipment using the CA certification
file.
Note
• When using the WPA/WPA2/802.1X with the PEAP
protocol, you must install the CA certification file in the
equipment using TopAccess first. For instructions on how to
install the CA certification using TopAccess, refer to
TopAccess Guide.
1
Press [WPA], [WPA2] or [802.1X], and then
[NEXT].
The AUTHENTICATION SETTINGS screen is displayed.
Note
• To select [TKIP] or [AES (CCMP)], press [WPA] or
[WPA2], or to select [DYNAMIC WEP], press [802.1X].
To Next Page
Loading...
