44473001TH Rev.1
141 /
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
Item1 Item2 Item3 Item4 Item5 Value
Default
value
ODA
Default
value
OEL
Default
value
JP
Notes
Password System
Maintenance
Change
Password
New Pass-
word
*********** Set a new password for accessing the maintenance menu.
6 to 12 characters (numerals and lower-case alphabetic characters) may be entered.
Verify
Pass-word
************ Have the user enter the new password for accessing the maintenance menu, set
using "NEW PASSWORD," for confirmation purposes.
6 to 12 characters (numerals and lower-case alphabetic characters) may be entered.
Check RTC Displays a snapshot of the current time. (The time does not change during display.)
Save Syslog Execute Saves the network communication log (syslog) to nonvolatile memory.
Print Syslog Execute Prints the network communication log (syslog).
Panel
Maintenance
Buzzer Test Low
Middle
High
Select the volume of the forced buzzer.
For the buzzer pattern, use the error sound (three buzzes)
Copy
Maintenance
Color Copy Enable
Disable
Switches between enabling and disabling pressing the color start key during
copying.
If this is set to "disabled," presses on the color start key in copy mode will be
rejected by the panel.
Print Check
Pattern
Execute Starts printing from the panel using a copy evaluation test chart inside the FW.
ADF
(Back-side)
Scanner
Calibration
Execute Starts execution of scanner calibration. Instead of being conducted automatically
after operating for a certain period of time, calibration is executed by the user as
needed. During calibration, the fact that calibration is underway is displayed.
Note: Also included under AdminSetting.
Adjust Scan
Position
FBS Side Reg. +8 ~ -8 mm 0 0 0 Adjust the starting read pixel position in the horizontal scanning direction during
book scanning.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
Front Edge +30 ~ -30 mm 0 0 0 During book scanning, add a value for the basic value (= 5 mm) when reading the
shadow of the front edge of the document.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
To Next Page
Loading...
Need help?
General
