Oki MC351 User Manual

44473001TH Rev.1
142 /
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
Item1 Item2 Item3 Item4 Item5 Value
Default
value
ODA
Default
value
OEL
Default
value
JP
Notes
Password ADF
(Back-side)
Adjust Scan
Position
ADF
(Front-side)
Side Reg. +8 ~ -8 mm 0 0 0 Adjust the starting read pixel position in the horizontal scanning direction when reading
a document from the ADF.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
Front Edge +30 ~ -30 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -30 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF
(Back-side)
Front Edge +30 ~ -30 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -30 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Adjust
ADF Scan
Position
+30 ~ -30 mm 0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to adjustment
of the ADF front edge position.
Adjust Mech. Adjust
Mech.
FB Drive
Current
1 ~ 140 Connect a panel or PC and set the electric current value of the scanner motor.
FB Keep
Current
1 ~ 140
ADF Drive
Current
1 ~ 140
ADF Keep
Current
1 ~ 140

Oki MC351 Specifications

General

Brand	Oki
Model	MC351
Category	All in One Printer
Language	English