165
Miscellaneous
12
Troubleshooting
The monitor is hard to see.
Corrective action
Adjust the brightness of the monitor using the
menu.
Block the sunlight with your hand.
A monitor cover is attached to this camera to
protect the monitor. Remove the monitor cover
when the picture is hard to see, or when you
want to check picture details.
Ref. Page
P. 129
–
P. 27
Possible cause
The brightness is not
adjusted properly.
The monitor is exposed to
direct sunlight.
The monitor cover is
attached to the camera.
The computer does not recognize the camera correctly.
Possible cause
The camera's power is
turned off.
The USB driver was not
successfully installed.
The camera's PC MODE is
set to CONTROL.
Connecting the camera to a PC
Corrective action
Set the power switch to
ON.
If your OS is Windows 98/98 SE, install the USB
driver again.
When PC MODE is set to CONTROL, images
cannot be downloaded with an application
(Microsoft Internet Explorer, etc.) on a computer.
Set PC MODE to STORAGE.
Ref. Page
P. 26
P. 146
P. 133
To Next Page
Loading...
