170
Miscellaneous
12
Maintenance
PIXEL MAPPING and dust reduction
The PIXEL MAPPING feature allows the camera to check and adjust the CCD and
image processing functions. It is not necessary to operate this function frequently.
Approximately once a year is recommended. After using the monitor or taking
continuous shots, wait for at least one minute before using the PIXEL MAPPING
function to ensure that it operates correctly. Dust reduction also works at the same
time to remove dust on the CCD.
1
In the menu, select T
PIXEL MAPPING, and press .
~ “How to use the menus” (P. 38)
2
Press OK button.
● The busy bar is displayed during PIXEL
MAPPING. When PIXEL MAPPING is
finished, the menu is restored.
Note
● If you accidentally turn the camera off during
PIXEL MAPPING, start again from Step 1.
● The following matter is not removed with the
dust reduction function:
– Sticky matter (solvent, etc.)
– Lightweight particles such as cotton dust
– Microscopic dust particles not visible to the
naked eye
To Next Page
Loading...
