50
3.6 Entering ID
OER-Elite OPERATION MANUAL
Ch.3
2 Then the scope ID list is displayed. When the Scope ID is not listed on the ID list, go
to “(a) Select a Scope ID that is not listed” on page 51. When the Scope ID is listed on
the ID list, go to “(b) Recalling the pre-registered ID” on page 54.
No. Item/Button Note
1 ID type Type of the currently edited ID.
2 Model # Registered model number of the endoscope. These areas are blank if no ID has been
registered.
3 Serial # Registered serial number of the endoscope. These areas are blank if no ID has been
registered.
4 Edit Press one of the buttons to open the ID information edit screen.
5 Set Press one of the buttons to set a registered ID.
6 Previous page
button
Press to return to the previous page. When there is no further page to turn back to, the
button turns gray and becomes unavailable.
7 Next page button Press to go to the next page. When there is no further page to go forward to, the button
turns gray and becomes unavailable.
8 Back Press to close the ID select screen.
1
6 7
2 3
8
4 5
To Next Page
Loading...
