Olympus OER-Elite - (a) Select each ID that is not listed

3.6 Entering ID
51
OER-Elite OPERATION MANUAL
Ch.3
(a) Select a Scope ID that is not listed
1 To set a new scope ID, press the “Edit” button
that no ID has been registered. To change the
registered Scope ID, press the “Edit” button of
the Scope ID.
Figure 3.18
2 The software keyboard (on-screen) is opened. Enter the model number of the
endoscope on the software keyboard.
No. Button Note
1 Alphabet/
Numeral key
Enter an alphabet or a numeral.
2 Uppercase/
Lowercase
Press “Uppercase/lowercase” button to switch alphabet character on the software
keyboard (on-screen) between uppercase characters and lowercase characters.
3 Numeric/
Alphabetic
Press “Numeric or Alphabetic” button to switch the input mode between a numeral and
the alphabet.
4 Backspace Press the “Backspace” button to delete the left character of a cursor.
When a cursor is on the left edge, this button turns gray and becomes unavailable.
5 Space Press the “Space” button to insert a space character.
6 Cursor move Press the “Cursor move” button to move the cursor left or right.
7 Delete Press the “Delete” button to delete about all information.
8 Cancel Return to the previous screen without saving the setting value.
9 Save Return to the previous screen and save the entered value.
41
2
3
5
6
8 9
41
2
3
5
6
8 9
Alphabet input Numeral input
7 7