52
3.6 Entering ID
OER-Elite OPERATION MANUAL
Ch.3
3 Press the “Serial #” button on the software
keyboard.
Figure 3.19
4 Enter the serial number of the endoscope.
Press the “Save” button, then the scope ID was
set to the reprocessing process.
Figure 3.20
5 The connection information screen is displayed on the touch screen. Connect the
suitable connecting tubes according to the “List of Compatible
Endoscopes/Connecting Tubes <OER-Elite>”, then press the “No Connection”
buttons corresponding to the reprocessing basin connectors to which the connecting
tubes are connected. The “No Connection” indicator will now change to “Connection”.
Figure 3.21
To Next Page
Loading...
