3.6 Entering ID
53
OER-Elite OPERATION MANUAL
Ch.3
6 Press the “OK” button.
Figure 3.22
7 The following message is displayed. After
reading the message, Press the “OK” button
again.
Figure 3.23
When the “Manual Cleaning and Leak Test Setting” is activated, select the manual
cleaning and leak testing results after Step 7. For detail, refer to “ Input results of
manual cleaning and leak test of second endoscope” on page 214.
8 Once the scope ID is entered, the ID select
screen appears. To go back to the reprocessing
standby screen, press “OK” button.
Figure 3.24
To Next Page
Loading...
