Be sure to return the disinfectant solution nozzle cap to the original position.
Otherwise, the disinfectant solution inside the nozzle may be diluted in the next
process and next MRC check will be failed even if the concentration of LCG in the
tank is above its MRC. In this case, perform mix LCG, then check MRC again.
Entering the check result
4 Attach the disinfectant solution nozzle cap to
the original position on the disinfectant solution
nozzle. Make sure that the pin returns to the
original position, and the projection of the
disinfectant solution nozzle cap is aligned to the
projection of the disinfectant solution nozzle.
Figure 3.47
1 Display the Reprocessing Standby screen and
Press the “MRC Check” button.
Figure 3.48
Pin
projection
To Next Page
Loading...
