10-2
10. Data Format Commands (P, G, R, W)
10.1 READING CONFIGURATION (“RdG.CNF”)
TABLE 10.1 READING CONFIGURATION
BIT POSITION RdG.CNF
76543210
0 dIRECt Direct Format for Rd.SC.OF
1 2.CdINt 2-Coordinate Format for Rd.SC.OF
0 dP.ACtV yES Active Decimal Point
1 dP.ACtV NO Independent Decimal Point
0 SP1.FLS dISABL SP1 Flashing
1 SP1.FLS ENAbLE SP1 Flashing
0 SP2.FLS dISABL SP2 Flashing
1 SP2.FLS ENAbLE SP2 Flashing
0 AL1.FLS dISABL AL1 Flashing
1 AL1.FLS ENAbLE AL1 Flashing
0 AL2.FLS dISABL AL2 Flashing
1 AL2.FLS ENAbLE AL2 Flashing
00 H.bRt HIGH BRIGHTNESS
01 M.bRt MEDIUM BRIGHTNESS
10 L.bRt LOW BRIGHTNESS
1 1 (Not Used)
EXAMPLE: To set Rd.SC.OF direct format, Decimal Point active, Display flashing as
input value reaches SP1 or Alarm1 (SP3) and Display LED’s at high brightness level:
The command data is 00010100 BIN. = 14 HEX. Then send *W0714
To Next Page
Loading...
