iv
Table 2.1 Meter Hookup (RS-232) to the Computer .............................................2-4
Table 2.2 Meter Hookup (RS-232) to the Printer...................................................2-4
Table 2.3 Half-Duplex Hookup (RS-485) to the Computer....................................2-5
Table 2.4 Full-Duplex Hookup to the Computer ....................................................2-6
Table 4.1 The ASCII Character Code....................................................................4-5
Table 4.2 Meter Receiving Voltages......................................................................4-6
Table 4.3 Meter Transmitting Voltages..................................................................4-6
Table 8.1 Command Prefix Letters (Command Classes)......................................8-3
Table 8.2 Command Letters and Suffixes .............................................................8-6
Table 8.3 Error Messages ...................................................................................8-11
Table 8.4 Alarm Status Characters .....................................................................8-13
Table 8.5 Peak/Valley Status Characters............................................................8-14
Table 8.6 Special Characters ..............................................................................8-15
Table 9.1 Reading Rate for Command Mode........................................................9-2
Table 9.2 Reading Rate for Communication ........................................................9-3
Table 10.1 Reading Configuration.........................................................................10-2
Table 10.2 Input Configuration .............................................................................10-3
Table 10.3 Count By and Decimal Point ...............................................................10-4
Table 10.4 Filter Configuration and Output Type .................................................10-5
Table 10.5 Setpoint Configuration.........................................................................10-6
Table 10.6 Alarm Configuration ............................................................................10-7
Table 10.7 Alarm Configuration and Mode ...........................................................10-8
Table 10.8 Alarm Delay.........................................................................................10-8
Table 10.9 Output Configuration ..........................................................................10-9
Table 10.10 Input Type and Reading Scale and Offset.........................................10-10
Table 10.11 Serial Communications Configuration ...............................................10-11
Table 10.12 Data Format .....................................................................................10-12
Table 10.13 Bus Format........................................................................................10-13
Table 10.14 Lockout Configuration ......................................................................10-14
Table 10.15 Lockout Configuration and Normal Color ..........................................10-15
Table 10.16 Color Configuration ..........................................................................10-16
Table 10.17 R/W40 (Block A) ...............................................................................10-17
Table 10.18 R/W41 (Block B)................................................................................10-19
Table 10.19 R/W42 (Block C) ...............................................................................10-21
Table 10.20 R/W43 (Block D)................................................................................10-22
Table 10.21 R/W44 (Block E)................................................................................10-23
Table 10.22 R/W45 (Block F) ...............................................................................10-23
Table 10.23 R/W50 ...............................................................................................10-24
Table 10.24 R/W50 NUM.PNt and MENU selection ............................................10-24
Table 10.25 R/W5XXXXX .....................................................................................10-25
Table 10.26 Setpoint Values ................................................................................10-26
Table 10.27 Serial Delay (“SER.dLy”) ..................................................................10-29
Table 10.28 Reading Scale(“RdG SC”),Input Scale(“INP SC”),Output Scale(“OUt SC”)....10-30
Table 10.29 Reading Offset(“RdG OF”),Input Offset(“INP OF”),Output Offset(“OUt OF”) ..10-31
Table of Contents
To Next Page
Loading...
Need help?
General
