OmniCell G4 - Remove;Replace the Power Entry Module; Remove the Power Entry Module

© 2011 Omnicell, Inc. OmniRx Service Guide/67-2023 Rev F
CT PC E-Box 6-19
Remove/Replace the Power Entry Module
2. Replace the screw that secures the wireless card to the E-Box frame.
Figure 6-29. Replace the screw that secures the wireless card
Remove/Replace the Power Entry Module
Remove the Power Entry Modu le
1. Remove the battery. Follow the steps in “Remove the Battery” on page 1-8.
2. Remove the power supply. Follow the steps in “Remove the Power Supply” on page 1-10.