Omron E5GN - Page 90

E5GN
5–23
Direct/reverse operation
Ă• Direct operation" refers to control where the manipulated variable is increased
according to the increase in the process value. Alternatively, reverse operation"
refers to control where the manipulated variable is increased according to the
decrease in the process value.
Setting Range Default
: Reverse operation/ : Direct operation
Alarm 1 type
The alarm 1 type must be supported.
The control must be set to standard control.
Ă• Select one of the following alarm 1 types:
Deviation/Deviation range/Absolute value
Initial Setting Level
Function
Setting
Function