Omron NS10-TV Series Programming Manual

Section 1 Overview 1-5 Procedure before Operation
1-32
NS Series Programming Manual
1-5 Procedure before Operation
Perform the following procedure to start the PT.
Host PT CX-Designer
Host settings
Panel installation
Installation on the
computer
1:1
NT
Li
n
k
1:N NT Link
High-speed 1:N NT Link
Ethernet (Refer to NS-Series
Setup Manual.)
EtherNet/IP (Refer to NS-Series
Setup Manual.)
Controller Link (Refer to NS-Series
Setup Manual.)
Host Link (Refer to Host
Connection Manual: Host Link.)
Temperature Controllers (Refer to
Host Connection Manual: Temp.
Control, MemLink.)
Memory Links (Refer to Host
Connection Manual: Temp.
Control, MemLink.)
For connection with other devices.
(Refer to Host Connection
Manual: Multivendor Connection.)
Peripheral connections
Power connections
System program installation
(
See note.
)
Refer to CX-Designer Online Help
and NS-series Setup Manual.
Refer to NS Series Setup Manual.
Screen creation
Refer to CX-Designer Online
Help and Programming
Manual.
Screen transfer
System menu settings
Refer to NS-series Setup Manual and CX-Designer Online Help.
Host connections
Settings/com check
Operation
System maintenance
Programming
PT connections
Refer to NS-series Setup Manual.
RS-232C (Refer to N
S
-Series Setup Manual.)
Ethernet (Refer to NS-Series Setup Manual.)
EtherNet/IP (Refer to NS-Series Setup Manual.)
Controller Link (Refer to NS-Series Setup Manual.)
Note: The system program is installed only in special circumstances, such as when the system program is re-
placed or repaired. (The system program is included with the NS-CXDC1-V
@ CX-Designer.)

Omron NS10-TV Series Specifications

General

Brand	Omron
Model	NS10-TV Series
Category	Touch terminals
Language	English