128
Section 6 Using the Zero Reset Function
ZX-E
Operation Manual
Section 6
AUXILIARY FUNCTIONS
Setting Offset Values
Set an offset value when the reference value for zero reset is a value other than 0.
Moving to FUN and SPCL
1. Set the mode switch to FUN.
2. Use the LEFT and RIGHT Keys to display
SPCL on the main display.
Moving to ZRDSP
3. Press the UP or DOWN Key.
The sub-display will flash.
4. Use the UP and DOWN Keys to display ETC
or ALL.
5. Press the ENT Key.
6. Use the LEFT and RIGHT Keys to display
ZRDSP on the main display.
Setting Offset Values
7. Press the UP or DOWN Key.
The leftmost digit of the sub-display will flash.
8. Use the Cursor Keys to set the offset value.
9. Press the ENT Key to confirm the setting.
The offset value will be registered.
Move between digits.
Increment and decre-
ment the numeric value.
Z166-E1-02A.book Page 128 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
