52
Section 3 Function Transition Charts
ZX-E
Operation Manual
Section 3
BASIC OPERATION
FUN Mode
Linearity adjustment
(See note 1.)
Hysteresis
Hold
Trigger mode
Special functions
Monitor focus
Scaling
ECO mode
Display reverse
Number of samples
to average
Previous value
comparison
Linear output
correction
Limited number
of display digits
Display during
zero reset
Zero reset
memory
Clamp value
setting
Settings for non-
measurement
Mutual interfer-
ence prevention
(See note 3.)
Note 1: Linearity adjustment is dis-
played first when you enter
FUN mode.
When CLOSE is selected, the special functions will not be displayed and
the display will return to LINER.
Note 2: Previous value compari-
son is displayed when
hold is not set to OFF.
Note 3: Mutual interference prevention is
displayed only on the CH1 Amplifier
Unit.
When ALL is selected, all special functions are displayed.
(See note 2.)
p. 54
p. 80
p. 102
p. 81
p. 83
p. 88
p. 107
p. 103
p. 90
p. 123
p. 126
p. 124
p. 120
p. 127
p. 130
p. 110
Z166-E1-02A.book Page 52 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
