13
ZX-E
Operation Manual
Preface How to Use This Manual
PREFACE
How to Use This Manual
Page Format
Section Title
Main Heading in
a Section
Indicates page contents.
Outline
Provides an outline or gives a
flowchart of the operation de-
scribed under the main heading.
Sub-heading
Index Label
Gives the section number and
subject matter.
Function Outline and
Suggestions
Operation
Indicates the operation to be
performed next.
Display Area
Shows the display status after
a step in an operation.
Keys and Switches
Provides an illustration of the keys or
switches used during the operation.
Procedure and Additional Explanations
Information useful during the operation and reference
pages are provided here with special marks to indicate the
kind of information being provided.
* This page does not actually exist in
this manual.
Section 3
Basic Operations
ZX-E Smart Sensor linearity is adjusted before shipment, however
more accurate linearity can be obtained by adjusting linearity again
for the actual sensing objects and operating environment.
Adjusting Linearity
This section describes how to set the sensing object material.
Selecting Sensing Object Material
To use the default linearity adjustment after changing materials,
select the material and then select Adjust.
Changing to T Mode
Set the mode switch to T.
Set the switch to the threshold value to
be set.
Press any Cursor Key.
The first digit of the threshold value displayed on
the sub-display will flash and direct input will be
enabled.
Change the threshold value with the Cursor
Keys.
To cancel the selected setting, use the LEFT
Key to move the cursor to the leftmost digit
and press the LEFT Key again. he display will
return to the current setting.
ZX-E
Operation Manual
Z166-E1-02A.book Page 13 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
