34
Section 2 Connections
ZX-E
Operation Manual
Section 2
PREPARATIONS FOR MEASUREMENT
Connections
This section describes how to connect component parts of the Smart Sensor.
Turn OFF the power supply to the Amplifier Unit before connecting or removing components. The Smart Sen-
sor may malfunction if components are connected or removed while the power is ON.
Sensor Heads
Do not touch the terminals inside the connector.
■ Connection Method
Push the Sensor Head connector into the Amplifier Unit connector until it locks.
■ Removal Method
When disconnecting the Sensor Head, hold the connector ring and the Amplifier Unit
connector and pull them straight out.
Do not pull only on the connector ring, because the input cable of the Amplifier Unit may be dam-
aged.
All settings on the Amplifier Unit will be cleared when the Sensor Head is replaced with a differ-
ent model.
Connector ring
Z166-E1-02A.book Page 34 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
