54
Section 3 Adjusting Linearity
ZX-E
Operation Manual
Section 3
BASIC OPERATION
Adjusting Linearity
ZX-E Smart Sensor linearity is adjusted before shipment, however more accurate linearity can
be obtained by adjusting linearity again for the actual sensing objects and operating
environment.
Adjust linearity before setting measurement conditions. Linearity should also be adjusted
again when Sensor Heads are replaced.
❚ Flow of Operation
Linearity p. 139
Selecting Sensing Object Material
This section describes how to set the sensing object material.
Linearity According to Material
Characteristic Data, p. 148
To use the default linearity adjustment after changing materials, select the material and then perform
Executing Adjustment.
Selecting Sensing
Object Material
Entering Adjustment
Values
Executing Adjustment
Selection Material
FE (default) Iron
SUS Stainless steel (SUS304)
AL Aluminum
Z166-E1-02A.book Page 54 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
