55
ZX-E
Operation Manual
Section 3 Adjusting Linearity
Section 3
BASIC OPERATION
Changing to FUN Mode and LINER
1. Set the mode switch to FUN.
2. Use the LEFT or RIGHT Key to display
LINER on the main display.
Setting Sensor Object Material
3. Press the ENT Key.
METAL will be displayed.
4. Press the UP or DOWN Key.
The sub-display will flash.
5. Use the UP or DOWN Key to select the mate-
rial.
6. Press the ENT Key to confirm the selection.
The setting will be registered.
Z166-E1-02A.book Page 55 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
