24
Section 2 Basic Configuration
ZX-E
Operation Manual
Section 2
PREPARATIONS FOR MEASUREMENT
Basic Configuration
The basic configuration of the ZX-E-series Smart Sensors is shown below.
ZX-L-series Smart Sensors (Laser Type) and ZX-E-series Smart Sensors (Inductive Displacement Type) are
not compatible. Do not use ZX-L-series and ZX-E-series Smart Sensors together.
Smart Monitor
(software)
ZX-SW11EV2
(Version 2.0 or later)
Controls Amplifier
Units from a
personal computer
and monitors
measured values.
Personal
computer
Interface Unit
ZX-SF11
(Version 2.0 or later)
Used when
connecting a
personal computer.
Basic Configuration
Sensor
Heads
ZX-ED@@T
ZX-EM@@T
ZX-EV@@T
Sensor Heads
detect the
sensing objects.
Extension
Cables
ZX-XC1A (1 m)
ZX-XC4A (4 m)
ZX-XC8A (8 m)
Used between
Sensor Heads and
Amplifier Units.
Amplifier Units
ZX-EDA11 or
ZX-EDA41
Process measure-
ments and output
measurement results.
Calculating Units
ZX-CAL2
Used when connecting
multiple Amplifier
Units.
• Perform calculations.
• Prevent mutual
interference
Power Supply
12 to 24 V DC (±10%)
p. 37
p. 25
p. 30
p. 35
Z166-E1-02A.book Page 24 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
