59
ZX-E
Operation Manual
Section 3 Adjusting Linearity
Section 3
BASIC OPERATION
Initializing Adjustment Settings
Initialize the linearity adjustment settings to return to the default settings.
This section describes how to initialize the linearity adjustment settings only. To initial-
ize other settings, use the INIT function.
Initializing Settings Data, p. 133
Moving to FUN Mode and LINER
1. Set the mode switch to FUN.
2. Use the LEFT and RIGHT Keys to display
LINER on the main display.
Initializing Settings
3. Press the ENT Key.
The display will show METAL.
4. Use the LEFT and RIGHT Keys to display
LINIT.
5. Press and hold down the ENT Key.
One dash (−) at a time will appear on the sub-display.
6. Release the ENT Key once OK is displayed
on the sub-display.
The adjustment settings have been initialized.
Z166-E1-02A.book Page 59 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
