25
ZX-E
Operation Manual
Section 2 Part Names and Functions
Section 2
PREPARATIONS FOR MEASUREMENT
Part Names and Functions
Amplifier Units
(1) The input cable connects the Sensor Head.
(2) The current/voltage switch selects either a current or voltage linear output.
Monitor focus settings are also required when switching the output.
p. 103
(3) The connectors connect Calculation and Interface Units.
(4) The output cable connects to the power supply and external devices, such as sync sensors or
programmable controllers.
(5) The Power ON indicator lights when the power is turned ON.
(6) The Zero Reset indicator lights when the zero reset function is enabled.
(7) The ENABLE indicator lights when the measurement result is within the measurement dis-
tance.
(8) The HIGH indicator lights when the judgement result is HIGH.
(9) The PASS indicator lights when the judgement result is PASS.
(10) The LOW indicator lights when the judgement result is LOW.
(11) The main display shows measured values and function names.
(12) The sub-display shows additional information and function settings for measurements.
Reading Displays, p. 47
(13) The threshold switch selects whether to set (and display) the HIGH or LOW threshold.
(14) The mode switch selects the operating mode. Switching Modes, p. 46
(15) The Control Keys set measurement conditions and make other settings.
Key Operations, p. 48
Display area (❋)
(1) Input cable
Controls (❋)
(4) Output cable
(3) Connectors (one on each side, two total)
(2) Current/voltage switch (back of Unit)
(8) HIGH indicator
(9) PASS indicator
(10) LOW indicator
(11) Main display
12
Sub-dis
la
13
Threshold switch
(14) Mode switch
(5) Power ON indicator
(6) Zero reset indicator
(15) Operating Keys
(7) ENABLE indicator
❋ Details of Controls
and Display Area
Current/voltage
output selector
Voltage output
Current output
Z166-E1-02A.book Page 25 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
