28
Section 2 Installing the Amplifier Unit
ZX-E
Operation Manual
Section 2
PREPARATIONS FOR MEASUREMENT
Installing the Amplifier Unit
Amplifier Units can be easily mounted to 35-mm DIN Track.
■ Installation
Hook the connector end of the Amplifier Unit on the DIN Track and press in at the bot-
tom until the Unit locks into place.
Always hook the connector end of the Amplifier Unit on the DIN Track first. Mounting strength
may decrease if the output cable end is hooked on the DIN Track first.
DIN Track (order separately)
PFP-100N (1 m)
PFP-50N (0. 5 m)
PFP-100N2 (1 m)
End Plates (order separately)
PFP-M
Hook on the connector end
Z166-E1-02A.book Page 28 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
