33
ZX-E
Operation Manual
Section 2 Installing Sensor Heads
Section 2
PREPARATIONS FOR MEASUREMENT
Preamplifiers
■ Installation
Use the enclosed Preamplifier Mounting Bracket.
The Preamplifier can also be mounted to 35-mm DIN Track.
Use the ZX-XBE2 Preamplifier DIN Track Mounting Bracket (order separately) when mounting
the Preamplifier to DIN Track.
1. Use M3 screws to fix the enclosed Preampli-
fier mounting bracket.
2. Snap one end of the Preamplifier into the
bracket.
3. Then snap the other end of the Preamplifier
into the bracket.
■ Removal Method
Hold the center of the Preamplifier and lift.
Mounting Dimensions
(Unit: mm)
Two, M3 holes
Z166-E1-02A.book Page 33 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
