Omron ZX-E - Page 143

141
ZX-E
Operation Manual
Appendices
Specifications and Dimensions
APPENDICES
Notes: 1. The response speed of the linear output is calculated as the measurement period x (No. of samples to
average setting + 1).
The response speed of the judgement outputs is calculated as the measurement period x (No. of samples
to average setting + 1).
2. The output can be switched between current output and voltage output using a switch on the bottom of the
Amplifier Unit.
3. Setting is possible via the monitor focus function.
4. A Calculating Unit is required.
Functions Measured value
display
Present value dis-
play
Output value dis-
play
Set value display
Resolution display
ENABLE indicator
Zero reset indica-
tor
Power ON indica-
tor
Judgement indica-
tor
ECO mode
Display reverse
Display digit limit
Zero reset
Zero reset memory
Previous value compari-
son
Initialization
Linearity initialization
Teaching
Direct threshold value
setting
Hysteresis width setting
Scaling
Linearity adjustment
Monitor focus
Linear output correc-
tion
Peak hold
Bottom hold
Sample hold
Peak-to-peak hold
Average hold
Delay hold
Delay time setting
ON-delay timer
OFF-delay timer
One-shot timer
Timing inputs
Self-up trigger
Self-down trigger
(A-B) calculations
(See note 4.)
(A+B) calculations
(See note 4.)
Thickness calculation
(See note 4.)
Mutual interference
prevention
(See note 4.)
Key lock
Clamp value setting
Indications Judgement indicators: HIGH (orange), PASS (green), LOW (yellow), 7-segment main display
(red), 7-segment sub-display (yellow), power ON (green), zero reset (green), enable (green)
Voltage influence
(including Sensor)
0.5% F.S. of linear output value at
±20% of power supply voltage
Power supply
voltage
12 to 24 VDC
± 10%, Ripple (p-p): 10% max.
Power consumption 3.4 W max. (Sensor connected)
(Power supply voltage: 24 V, Current consumption: 140 mA max.)
Ambient
temperature
Operating and storage: 0 to 50
°C (with no icing or condensation)
Ambient humidity Operating and storage: 35% to 85% (with no condensation)
Insulation
resistance
20 M
Ω min. at 500 VDC
Dielectric strength 1,000 VAC, 50/60 Hz for 1 min
Vibration resistance
(destructive)
10 to 150 Hz, 0.7-mm double amplitude 80 min each in X, Y, and Z directions
Shock resistance
(destructive)
300 m/s
2
3 times each in six directions (up/down, left/right, forward/backward)
Connection method Prewired (standard cable length: 2 m)
Weight (packed
state)
Approx. 350 g
Materials Case: PBT (polybutylene terephthalate), Cover: Polycarbonate
Accessories Instruction sheet
ZX-EDA11 ZX-EDA41
Z166-E1-02A.book Page 141 Friday, June 3, 2005 4:18 PM