37
ZX-E
Operation Manual
Section 2 Connections
Section 2
PREPARATIONS FOR MEASUREMENT
Interface Units
Use an Interface Unit to connect a personal computer to the Smart Sensor system.
■ Connection Method
1. Open the connector cover on the Amplifier Unit.
Open the connector cover by lifting and sliding it open.
2. Mount the Interface Unit to the DIN Track.
3. Slide and connect the Interface Unit to the Amplifier Unit connector.
Perform the above operation in the reverse order to remove Interface Units.
When multiple Amplifier Units are used, connect the Interface Unit to the Amplifier Unit with the
highest channel number.
Z166-E1-02A.book Page 37 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
