Omron ZX-E - Page 70

68
Section 4 Measuring Height
ZX-E
Operation Manual
Section 4
MAIN APPLICATIONS AND SETTING METHODS
Mounting to Device
Mount the Sensor Head to the inspection device.
Refer to the following diagram and prepare a mounting jig.
Installing Sensor Heads, p. 30
Adjusting Measurement Distances
Place the reference sample in position and adjust the Sensor Head position. Refer to
the Amplifier Unit display and adjust the Sensor Head position so that the upper and
lower limits of the height (H) to be measured fall within the measurement distance.
Measurement distance, p. 143
Measured Value Display
The Amplifier Unit display shows the distance (H) from the reference sample (default).
The display can also be set to show the height of the reference sample.
Changing Display Scales, p. 90
Mounting jig
(resin or metal)
Set screw
Height of reference sample
Z166-E1-02A.book Page 68 Friday, June 3, 2005 4:18 PM