94
Section 5 Changing Display Scales
ZX-E
Operation Manual
Section 5
DETAILED SETTINGS
15. Press the ENT Key to confirm the settings.
The inverted display settings will appear on the sub-dis-
play.
Selecting Inverted Display
16. Use the UP and DOWN Keys to inverted dis-
plays.
17. Press the ENT Key to confirm settings.
The sub-display will be P2SCL.
18. Press the ENT Key.
Confirming that Scaling Is Completed
If scaling has been completed correctly, the display will
be OK.
If scaling was unable to be completed, the display will be
NG.
Check that the sensing object is within the measurement
distance and execute scaling again.
Options Details
D-FWD Not inverted.
D-INV Inverted
(Inverts the increase/decrease relationship
between display and measured values)
Z166-E1-02A.book Page 94 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
