Safety
Version 1.0.4 - 2020-08-0414 Translation of original instruction
MT60
EN
MT60_GB_1.fm
1.10 Safety check
Check the milling machine at least once per shift. Inform the person responsible immediately of
any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (when the machine is operated continuously),
once per day (during one-shift operation),
once per week (when operated occasionally),
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the milling machine
are legible (clean them, if necessary)
and complete (replace them, if necessary).
INFORMATION
Organise the checks according to the following table;
1.11 Personal protective equipment
For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces or tools with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
General check
Equipment Check OK
Signs, Markings Installed and legible
Date: Checked by (signature):
Functional check
Equipment Check OK
Emergency stop
push button
After actuating an emergency stop push button the mill-
ing machine must be switched off.
Spindle guard The spindle drive can only be switched on if the spindle
guard is in the machining position.
Date: Checked by (signature):
To Next Page
Loading...
