Optimum OPTImill MT 60 - Positioning to a Coordinate Point on the Arc

Operation
Version 1.0.4 - 2020-08-04 53Translation of original instruction
DPA21 EN
DPA21_GB_3.fm
5.9.2 Positioning to a Coordinate Point on the Arc
INFORMATION
Press the button to temporarily interrupt the function. The display returns to the normal
display status. Press the 0 key again to continue with the function.
Press the button to exit from the function.
Parameter Description
1 - 6 E_Po End position: X-Y
2 - 6 E_Po End position: Y-Z
3 - 6 E_Po End position: X-Z
To enter the end position, use the numeric keys and confirm with the key.
Parameters Description
1 - 7 CUF Machining depth: X-Y
2 - 7 CUF Machining depth: Y-Z
3 - 7 CUF Machining depth: X-Z
To enter the machining depth, use the numeric keys and confirm with the key.
Parameters Description
1Po Position: X-Y
2Po Position: Y-Z
3Po Position: X-Z
To select the desired coordinate point, press the button.
Press button to select the desired coordinate point.
The machine axes will proceed until the positions of the selected coordinate axes read 0.000. Repeat
these steps until the arc has been completely machined.